If chapter title or appendix title is longer than one line, hit Enter key where needed to force words to the next line (do not extend words into column of page numbers) and then hit Tab key twice. If you have not yet typed your titles or pages numbers:įor the chapter title or appendix title, hit the Tab key once. This will indent the line 0.25 inch. Type your chapter number and the title. To finish and go back to your document click OK. Tab (2): Extra indentation for chapter titles or appendix titles that are longer than one line.Tab (1): Chapter titles or appendix titles (indent for entire line, including the chapter number or appendix letter).The Show/Hide command button typically appears under the HOME tab. ![]() Paragraph returns or enters will appear as the ¶ symbol. Spaces will appear as a tiny solid dot in the middle of the line. This will reveal where you have hit tabs, enters, and spaces. Tabs will appear as a single right-facing arrow. It is advisable to click on the Show/Hide command button which has this symbol, ¶.Then enter the next tab stop position ( repeat process for each new tab). Click the Set command button (you must complete this step for each tab you want to create). Next, click on the needed Alignment and the needed Leader. Basic Instructions: Place your cursor in the Tab stop position field and enter the first tab stop position.Click on the Clear All command button. This will clear all tabs that may still be in your table of contents.This will bring up the Tabs Dialog Box.Īll of the following instructions are based on the following margins: Then click on the Tabs command button in the bottom left-hand corner. In the "Spacing" section near the middle of the Paragraph Dialog Box, set line spacing to "Single" and line spacing boxes (marked "Before and "After") to "0 pt"īring up the Paragraph Dialog Box as described in step 7. ![]() ![]() Set to single-line spacing: In the HOME tab or the PAGE LAYOUT tab, click on the small box to the right of the word "Paragraph" to bring up a dialog box.Clear the format settings: In the HOME tab, under the Font Group, the top right icon is the Clear Format command button (looks like the letter A partially covered by a red eraser).Select all text and leave selected through steps 6 and 7 and throughout the tab setting process.The last word of each title and its page number should be joined as one.Delete any periods (or dots) you may have used to create "dot leaders" from the words of a listing to the page number. ![]()
0 Comments
Leave a Reply. |